Ri Connection And Setting; Rename The Input Selector; To Program The Ri Remote Control Code - Onkyo TX-NR545 Manual

Connecting and Operating Onkyo RI Components
RI Connection and Setting
Connect an Onkyo component with RI jack to this unit using an RI cable and
an analog audio cable. For details, refer to the instruction manual of the
component with RI jack. The RI cable can be connected in any order. When
there are two RI jacks, both jacks work in the same way and are
interchangeable.
To connect the RI Dock or cassette tape deck via RI, the following settings
are required.
Rename the input selector
To make the RI functions work, you must rename the input selectors on the
unit. Press CD or GAME to display "CD" or "GAME" on the main unit display.
Then press and hold CD or GAME 3 seconds or more to switch the display
to "DOCK" or "TAPE".
To program the RI remote control code
Program the remote control code to any REMOTE MODE button on the
remote controller. This will allow you to operate the component by pointing
the remote controller at the unit instead of the component.
1. Press and hold DISPLAY for 3 or more seconds while holding down the
REMOTE MODE button to which you want to program the remote control
code.