Connecting An Onkyo Component With A Dc Output (European Model); Changing The Receiver's Id - Onkyo UWL-1 Instruction Manual

Setting Up the UWL-1—Continued

■ Connecting an Onkyo Component with a DC Output (European Model)

Miniplug-to-RCA audio cable
Optical digital audio cable
OPTICAL
R L
LINE 1
IN
I N
DIGITAL
Onkyo component with DC output

Changing the Receiver's ID

The Receiver is set to the same ID as the Transmitter before it leaves the factory, so normally
you don't need to change it. However, if you have several Receivers and want them all to
receive audio from the same Transmitter, you'll need to set them all to the same ID.
1
With your PC on, plug the Transmitter into a USB port, and then connect the
AC adapter to the Receiver.
2
Put the Receiver close to the Transmitter (30–100 cm apart).
3
Press and hold down the Receiver's [CH SELECT] button for at least 3 sec-
onds, and then press and hold down the Transmitter's [CH SELECT] button
for at least 6 seconds.
The Transmitter's Transmit indicator and the Receiver's STANDBY indicator both flash,
and the Receiver detects the Transmitter's ID. Once the Receiver has recognized the Trans-
mitter's ID successfully, the Receiver's SYNC indicator lights up.
Receiver (RX-1)
STANDBY indicator
Connect one or the other.
Dedicated DC power cable*
DC5V
2W/0.4A MAX.
* Use the included dedicated DC power cable only with Onkyo
DC OUT
components that have a DC output. Don't use it for any other
purpose.
Note: When you use the dedicated DC power cable, use the
included optical digital audio cable for the audio connection, as
the audio quality may suffer with an analog audio connection. If
you do use an analog connection, use the included AC adapter
instead of the dedicated DC power cable.
CH SELECT button
SYNC indicator
Receiver (RX-1)
Transmit indicator
30–100 cm apart
Transmitter (UTX-1)
CH SELECT button
11