4.8
Replacement of modules
Replace PCB2.2, Analogue Connector
☞ 4.2 BeoLab 18 in service position 1
☞ 4.4 BeoLab 18 in service position 2
☞ 4.6 BeoLab 18 in service position 3
☞ 4.10 Remove PCB30, Digital Sound Engine
☞ 4.7 Remove PCB2.1, Digital Connector
- Remove screws
- Cut the foam tape along the dotted lines
- Gently lift up PCB2.2, Analogue Connector and
connector panel
- Disconnect cable
When reassembling, remember to place
the four foam washers on the reset button
4x
TX10
P101