Bang & Olufsen BeoLab 18 Service Manual page 25

PCB89, Wireless Power Link Rx - when backup function is not possible
Replace
Connecting speaker wirelessly
Speaker units
Calibration of speaker driver
The replace function in ServiceTool is used when it is not possible to perform a
Backup/Restore of the module.
Connect ServiceTool, launch BeoLab 18 and follow the procedure under Repair
-> Chassis.
After replacement of PCB89, Wireless Power Link Rx the speaker must be set up in
the wireless system correctly. Depending on the setup, there will be a few settings.
Setup with BeoLab Transmitter 1:
- Press the RESET button on the speaker (set speaker in associate mode)
- Press SELECT and STORE simultaneously between 1.5 and 10 seconds to reset
association on the BeoLab Transmitter 1
- Press SELECT to make a rescan on BeoLab Transmitter 1
Setup with product equipped with Wireless Power Link Tx:
- Press the RESET button on the speaker (set speaker in associate mode)
- Delete speaker in menu of the product equipped with Wireless Power Link Tx
- Perform a rescan in menu of the product equipped with Wireless Power Link Tx
Calibration of speaker driver is necessary when a speaker unit is replaced. The aim
is to ensure optimal sound even if the new speaker unit varies from the old
speaker unit. Use the read function to enable the calibration data fields.
Connect ServiceTool, launch BeoLab 18 and follow the procedure under
Adjustments -> Speaker calibration.
Adjustments 3.5