Replacement of modules
Modules
Antennas
Speaker units
Notification
Warning - Static electricity
ESD
ESD-Mat
After replacement of modules
BeoLab 18 in service position 2 ......................................................... 4.4
Replace Tweeter .............................................................................. 4.20
Replace Woofers ............................................................................. 4.21
Static electricity may damage the product.
A static-protective field service kit must always be used when the product is
disassembled or modules are being handled.
Notice!
All modules must be placed on the ESD-mat or in an ESD-proof bag.
- When BeoLab 18 has been disassembled, all affected sealings must be visually
checked and replaced, if damaged.
- Calibration of speaker driver is necessary when a speaker unit is replaced. Refer to
adjustment page 3.5.
- Back up product data from the old PCB30, Digital Sound Engine and restore it to
the new module after replacement. Refer to adjustment page 3.3.
- After replacement of PCB30, Digital Sound Engine the new module must be
updated to the latest software version. Refer to page 3.6.
- After replacement of PCB89, Wireless Power Link Rx the speaker must be set up in
the wireless system correctly. Refer to adjustments page 3.4-3.5.
- Always perform a 'Final check after repair' after the product has been dismantled.
Refer to final check after repair page 3.7.
Replacement of modules
Replacement of modules
4.1
4.1