Bang & Olufsen BeoLab 18 Service Manual page 24

3.4 Adjustments
PCB89, Wireless Power Link Rx - when backup function is possible
Backup/Restore
Connecting speaker wirelessly
This function is used when PCB89, Wireless Power Link Rx is replaced and it is still
possible to communicate with the old module. The following data is handled:
- ID number
- Serial number
- Type number
- Item number
- Calibration of speaker units
- Calibration of the amplifier
- Product settings
- Wireless data
- A new calibration of the amplifier is performed again.
Connect ServiceTool, launch BeoLab 18 and follow the procedure under
Repair -> Chassis.
After replacement of PCB89, Wireless Power Link Rx the speaker must be set up in
the wireless system correctly. Depending on the setup, there will be a few settings.
Setup with BeoLab Transmitter 1:
- Press the RESET button on the speaker (set speaker in associate mode)
- Press SELECT and STORE simultaneously between 1.5 and 10 seconds to reset
association on the BeoLab Transmitter 1
- Press SELECT to make a rescan on BeoLab Transmitter 1
Setup with product equipped with Wireless Power Link Tx:
- Press the RESET button on the speaker (set speaker in associate mode)
- Delete speaker in menu of the product equipped with Wireless Power Link Tx
- Perform a rescan in menu of the product equipped with Wireless Power Link Tx