Table of Contents
Advertisement
5 OPERATION
5.6
Connect to cooler EC 1001 (ET 210iP only)
NOTE!
Take care so that the interface cable does not get squeezed between the power source and
the cooling unit!
NOTE!
Power supply of the cooling unit is done from the welding power source via the connection
cable (for more information, refer to the cooling unit instruction manual).
5.7
Fan control
The ET 180iP and ET 210iP are fitted with a fan as an additional feature. When cooling fan is not in
use, the fan will automatically turns off.
This has two advantages:
1. To minimize power consumption,
2. To minimize the amount of pollutants absorbed into the power source, such as dust.
NOTE!
When cooling requires, the fan will operate otherwise it will automatically turn off.
5.8
Thermal protection
The power source includes thermal protection against overheating. When overheating
occurs the welding is stopped and overheating indicator on the panel will be lit and an
error message ERR 206 shows in the display. The protection is automatically reset
when the temperature has been sufficiently reduced.
0463 862 001
- 18 -
© ESAB AB 2023
Advertisement
Table of Contents
