Code 3 SuperVisorTL Installation & Operation Manual page 4

Step 5 Mounting the SuperVisorTL™
Once all four brackets and sun visors are attached, the SuperVisorTL is now ready to be installed. Rotate the rear view mirror down as
far out of the way as possible. Route the power cable across the top and along the passenger side of the SuperVisorTL, then route it
through the notch provided on the front and passenger side of the outer panel. This will prevent it from interfering with the head liner or
the windshield during installation. Carefully move the SuperVisorTL into position by tilting one end up with the front outer tip of the
SuperVisorTL in front of the corner post of the Crown Vic as shown in Figure 9, then swing the other end up into position being very
careful not to scratch the Crown Vic's plastic corner post covers (Note: It may be helpful to have an assistant gently push on the
vehicle's plastic corner door post cover as you swing the SuperVisorTL into position to prevent scratching the plastic
cover. Also make sure there is no slack in the SuperVisorTL's power cable and it is not interfering with the positioning
of the SuperVisorTL). Line up the mounting holes in the outer mounting brackets with the threaded holes in the SuperVisorTL and
thread the supplied 1/4"-20 bolts and internal tooth lock washers into the SuperVisorTL's Outer Panel (see Figure 10). Next line up the
mounting holes in the Inner mounting brackets with the threaded holes in the SuperVisorTL and loosely thread the supplied 1/4"-20 bolts
and internal tooth lock washers into holes in the SuperVisorTL's Outer Panel (see Figure 11).Tighten the 1/4-20 bolts in the Outer
Mounting Brackets (see Figure 12), then tighten the three Torx screws in each of the two outer Pivot Brackets.Tighten the two center
inner mounting screws, then while pushing up on the SuperVisorTL's Outer Panel, tighten the last two 1/4-20 bolts at the Inner Mounting
Brackets (see Figure 13).
9
FIGURE
12
FIGURE
The bracket fasteners make excellent hard mounting points for radar guns and video
cameras etc.
Caution:Drilling into the housing of the lightbar could damage wiring or other internal
components.
10
FIGURE
13
FIGURE
11
FIGURE