Iap Upgrade Notes; Chatper 9 Repeater Networking Mode - Ebyte E29-T Series User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.
Router（repeater mode）
Data_rssi（data RSSI）
Ldo（LDO mode switch）
Addr（module address）
Channel（module channel）
Netid（network ID）
Delay（WOR delay sleep time）

8.3 IAP upgrade Notes

If the customer needs to upgrade the firmware, please find the corresponding BIN file provided by the official,
and then use the official host control software to upgrade the firmware. Generally, the user does not need to
upgrade the firmware.
The pins necessary for the upgrade must be led out (M1, M0, AUX, TXD, RXD, VCC, GND), and then send
the "AT+IAP" command in the configuration mode to enter the upgrade mode.
mode, you need to keep Power on and wait for 60 seconds, the program will automatically exit, otherwise it will
enter the upgrade mode infinitely even if it is restarted.
After entering the upgrade mode, the baud rate will automatically switch to 115200 until it exits automatically,
during which there will be log output.

Chatper 9 Repeater networking mode

No.
User need to set the repeater function in configuration mode. After setting, switch module to the normal mode. Then the repeater starts
1
working.
In the repeater mode, ADDH/ADDL is no longer used as the module address, it is used as a NETID to pair and forwarding. If the reperater
2 receive the data from a network, then it will forward the data to the other network.
The network ID of the repeater itself is invalid in this case. (See below examples)
3 The repeater module cannot transmit and receive data, and cannot perform low-power operation.
When module enters the other modes from mode 3 (sleep mode) or during the reset process, it will reset the user parameters. During this
4
period, AUX outputs low level.
Repeater networking rules:
1. Forwarding rules: the repeater can forward data in both directions between two NETIDs.
2. In repeater mode, ADDH\ADDL is no longer used as the module address. It is used as a NETID to pair and forwarding.
As shown in the figure：
① Primary repeater
"Node 1" NETID is 08.
"Node 2" NETID is 33.
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd.
Key（key）
Please do not use the "AT+IAP" command .
0: close 1: open
0: close 1: open
0:DCDC 1:LDO
Module address 0~65535（Decimal）
Module channel 0~83（Decimal）
Module network 0~255（Decimal）
Module key 0~65535（Decimal）
delay sleep time 0~65535（Decimal）
Repeater mode description
E29-400TXXX product data sheet
If you need to exit the IAP upgrade
22