Factory Default Parameter; Repeater Networking Mode - Ebyte E22-400T22S1C User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.
07H Write CRYPT_H
08H Write CRYPT_L
80H~ Read
PID
86H only

7.3 Factory default parameter

Model No. Frequency
E22-400T22S1C 433MHz

8 Repeater networking mode

No.
1 After setting the repeater mode by configuration, switch to the normal mode and the repeater starts working.
In the repeater mode, ADDH, ADDL are no longer used as the module address, but is correspondingly paired with the
2 NETID. If the data of one of the networks is received, it is forwarded to another network. The network ID of the repeater
itself is invalid.
3 In repeater mode, the repeater module cannot transmit and receive data, and cannot perform low-power operation.
The user enters the other mode from mode 3 (sleep mode) or during the reset process, the module resets the user
4
parameters during which the AUX outputs low level.
Repeater networking rules:
1. Forwarding rules, the repeater can forward data in both directions between two NETIDs.
2. In repeater mode, ADDH\ADDL is no longer used as the module address, and it is used as a NETID forwarding pairing flag.
Figure:
Primary repeater
1
"Node 1" NETID is 08.
"Node 2" NETID is 33.
Primary repeater 1's 'ADDH\ADDL are 08，33.
Copyright ©2012–2018，Chengdu Ebyte Electronic Technology Co.,Ltd.
101：3000ms
110：3500ms
111：4000ms
Key high byte (default 0）
Key low byte (default 0)
Product information 7 bytes
Factory default parameters：C0 00 00 62 00 17
Address Channel
0x0000 0x17
 Write only, read returns 0
Used for user encryption to avoid intercepting

airborne wireless data by similar modules.
The module will internally use these two bytes as

a calculation factor to transform and encrypt the
over-the-air wireless signal.
 Product information 7 bytes
Air data rate Baud rate
2.4kbps 9600
Description
E22-400T22S1C User manual
Parity format Power
8N1 22dbm
18