Table of Contents
Advertisement
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
5-1. Disconnect the power by turning off the circuit breakers to the
outlet box and associated wall switch location.
5-2. To connect the wires, hold the bare metal leads together and place
a wire nut over them, then twist clockwise until tight. For all these
connections use the larger wire nuts provided.
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
5-3. Connect the wires as follows:
• e ground wire from the ceiling to the green ground wire
from the ceiling plate and the green ground wire from the
downrod or low profile washer
• e white (common) power wire from the ceiling to the longer
white wire from the receiver
• e black power wire from the ceiling to the longer black wire
from the receiver
5-4. Push all wires and wire nuts back through the ceiling plate hole
into the outlet box.
5-5. Run the white antenna wire from the receiver through one of the
slots in the ceiling plate so that it rests between the ceiling plate
and the ceiling. Push it to the edge of the ceiling plate for clear
reception.
41880-01 • 05/13/04
5 • Wiring the Fan
Receiver
Steps 5-2 – 5-3
Wire Nut
9
Hunter Fan Company
Advertisement
Table of Contents
