Table of Contents
Advertisement
Note that you will use the longer black wire and white wire
coming from the remote receiver later when wiring to the power
wires from the ceiling. You will connect all the ground wires later
too.
3-7. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim of the canopy.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-8. Align the hooks on the receiver with the appropriate slots in the
ceiling plate. Also be sure the slot in the receiver and the hook in
the ceiling plate line up. Snap the receiver into place on the ceiling
plate.
CAUTION: e remote control device complies with part 13 of the
FCC rule. Changes or modifications not expressly approved by Hunter
Fan Company could void your authority to operate this equipment.
Operation is subject to the following two conditions:
1. is device may not cause harmful interference.
2. is device must accept any interference received, including
interference that may cause undesired operation.
Note: Use with a fan that incorporates an air gap switch (normal on-off
wall switch).
WARNING: Maximum fan load is 100 Watts; maximum lamp is 300
Watts. Do not use any speed control with this product.
41880-01 • 05/13/04
Step 3-7
Step 3-8
Receiver
Hook
U-shaped
Hole
7
Receiver
Hunter Fan Company
Advertisement
Table of Contents
