Tuning In A Radio Station - Onkyo TX-SE350 Instruction Manual

Tuning in a radio station

TUNING Up/Down buttons
Use these buttons to tune the frequencies up and down.
PRESET station buttons
Use these buttons to store and recall the preset stations.
Input Selector (FM/AM)buttons
Use these buttons to select the FM/AM band.
MEMORY button
Press this button to store the station.
1
FM
2
MEMORY FM MUTE / MODE
18
Input selector TUNER button
GROUP button
AM
PRESET
TUNING
CLEAR
SCAN button
Use this button to scan the preset stations.
GROUP button
Use this button to select a group of preset stations.
Manual tuning
1. Press either the FM or AM button on the main unit.
2. Change the frequency using the √ √ √ √ or ® ® ® ® TUNING button.
Press the √ TUNING button to decrease the frequency and
press the ® TUNING button to increase the frequency.
The ®TUNED√ indicator on the display lights up when the
station is properly tuned in.
In FM, each press of a TUNING button changes the frequency in
50 kHz steps; in AM, the frequency changes in steps of 9 or
10 kHz, depending on the area in which the unit is used.
While tuning an FM station, if a button is continuously held down
for more than 0.5 seconds, the frequencies are scanned and tuning
automatically stops when a broadcast is received.
Tuning in an FM stereo radio station
When you tune in a stereo FM station, the FM STEREO indicator
lights up if the signal is sufficiently strong. If the signal is weak, it
may be impossible to tune in the station.
1. Press the FM MUTE/MODE button on the main unit.
The FM MUTE indicator turns off. This changes the broadcast
to mono, so interstation noise can be heard.
2. Select the station to which you want to listen.
FM MUTE/MODE button
Use this button to set the signal to
monaural so that weak FM stereo
reception with noise will become
more audible.
PRESET station buttons