Details On Am/Fm Reception; Tuning Into A Radio Station - Onkyo TX-SR444 Basic Manual

Details on AM/FM reception

Tuning into a Radio Station

 Tuning Automatically
¼
1. Press TUNER on the remote controller several times to
select either "AM" or "FM".
2. Press TUN MODE so that the "AUTO" indicator on the
display lights.
3. Press the cursors / to start automatic tuning.
● Alternatively you can press TUNING on the main
unit to start tuning automatically.
● Searching automatically stops when a station is
found. When tuned into a radio station, the
" TUNED " indicator on the display lights. When
tuned into an FM radio station, the "FM STEREO"
indicator lights.
● No sound is output while the " TUNED " indicator
is off.
En-2
When the signal from an FM radio station is weak:
Radio wave may be weak depending on the building
structure and environmental conditions. In that case,
perform the procedure as explained below in "Tuning
Manually" to manually select the desired station.
 Tuning Manually
¼
1. Press TUNER on the remote controller several times to
select either "AM" or "FM".
2. Press TUN MODE so that the "AUTO" indicator on the
display goes off.
3. While pressing the cursors / , select the desired radio
station.
● Alternatively you can press TUNING on the main
unit.
● The frequency changes by 1 step each time
you press the button. The frequency changes
continuously if the button is held down and stops
when the button is released. Tune by looking at the
display.
To return to automatic tuning: Press TUN MODE on the
remote controller again. The unit tunes automatically into a
radio station. Normally "AUTO" should be displayed.
Details on AM/FM reception
 Directly inputting the frequency
¼
It allows you to directly enter the frequency of the radio
station you want to listen to.
1. Press TUNER on the remote controller several times to
select either "AM" or "FM".
2. Press D.TUN.
3. Using the number buttons, enter the frequency of the
radio station within 8 seconds.
● To enter 87.5 (FM), for example, press 8, 7, 5, or 8,
7, 5, 0. If you entered a wrong number, press D.TUN
and enter a correct one.