Tuning In A Radio Station - Onkyo TX-SV353 Instruction Manual

Tuning in a radio station

DOWN
SYSTEM
DOLBY SURROUND
P R O • L O G I C
ON OFF
SPEAKERS A
STAND-BY
SPEAKERS B
SURROUND
MODE
PHONES
VIDEO / 1 VDP
1
FM
2
1
2
DIRECT TUNING
3
14
TUNING UP
DIRECT TUNING
1 2 3
4 5 6
7 8 9
GROUP 0/10 SCAN
TUNING
CENTER DOWN UP DIRECT TUNING
MODE DELAY TIME MEMORY FM MUTE / MODE
CLEAR
BASS
VIDEO / 2 VCR TV/AUX TAPE(MONITOR) FM AM PHONO C D
AUDIO VIDEO CONTROL RECEIVER
FM AM
FM MUTE / MODE
AM
TUNING
DOWN UP
FM AM
1 2 3
4 5 6
7 8 9
0/10
FM MUTE / MODE
MASTER VOLUME
Number buttons
MIN MAX
TREBLE BALANCE
L R
TX-SV 353
Manual tuning
1. Press either the FM or AM button on the main unit.
2. Change the frequency using the √ √ √ √ DOWN or UP ® ® ® ®
TUNING button.
Press the √ DOWN TUNING button to decrease the fre-
quency and press the ® UP TUNING button to increase
the frequency.
The TUNED indicator in the display lights up when the
station is properly tuned in.
In FM, each press of a TUNING button changes the fre-
quency in 100 or 50 kHz steps; in AM, the frequency
changes in steps of 9 or 10 kHz, depending on the area
where the unit is used.
If a button is continuously held down for more than 0.5 sec-
onds while tuning an FM station, the frequencies are scanned
and tuning automatically stops when a broadcast is received.
Direct tuning
1. Press either the FM or AM button on the main unit.
2. Press the DIRECT TUNING button.
"-- --" flashes in the display for 16 seconds.
3. While "-- --" flashes, enter the frequency using the
number buttons.
For example, to enter "88.10 MHz", press the 8, 8, 1,
then 0/10 number buttons.
The TUNED indicator in the display lights up when the
station is properly tuned in.
If you enter a frequency that is out of range, the frequency
display will flash and the unit will return to the previous fre-
quency.
Worldwide models (in 10 kHz step mode):
Since the AM frequency changes in 10 kHz steps, any num-
ber entered in the 1 kHz digit position automatically changes
to 0.
Tuning in an FM stereo radio station
If you tune in a stereo FM station, the STEREO indicator
lights up if the signal is sufficiently strong. If the signal is
weak, it may be impossible to tune in the station.
1. Press the FM MUTE/MODE button on the main unit.
The FM MUTE OFF indicator lights up. This changes
the broadcast to mono, so interstation noise can be heard.
2. Select the station to which you want to listen.