Listening To Your Favorite Source - Onkyo TX-SE350 Instruction Manual

Listening to your favorite source

1. Press the SPEAKERS A button.
The SPEAKERS A indicator lights up.
2. Press the desired input selector button or MULTI-CH INPUT (e.g. VIDEO-1).
4. Adjust the volume to an appropriate level using the MASTER VOLUME control knob
on the receiver or the VOLUME π(up) /†(down) buttons on the remote controller.
Speaker selector
SPEAKERS A:
This button turns on or off the speakers connected to the FRONT
SPEAKERS A, CENTER SPEAKER, SURROUND SPEAKERS
and SUBWOOFER terminals. When the speakers are turned on, the
SPEAKERS A indicator lights up.
SPEAKERS B:
This button turns on or off the speakers connected to the FRONT
SPEAKERS B terminals. When the speakers are turned on, the
SPEAKERS B indicator lights up.
Note:
You cannot use A and B speakers simultaneously.
When you select Dolby Pro Logic, Hall or Multi-CH Input, be
sure to turn on SPEAKERS A.
The subwoofer outputs sound only when SPEAKERS A is set to
ON.
14
The selected source (e.g. VIDEO-1) appears on the display.
Note:
Make sure that the TAPE MONITOR indicator is off when a source other than the TAPE (MONITOR) has
been selected. Also check to make sure the audio muting is off.
2
4
3. Start playing the selected input source.
Follow the operating instructions of the source device.
5. Adjust the bass and treble.
BASS: Boosts or cuts the bass response.
TREBLE: Boosts or cuts the treble
response.
Balancing the volume level among the speakers when MULTI-
CH INPUT is selected:
If you selected MULTI-CH INPUT in Step 2, you need to adjust
the level balance of the connected speakers.
1. Use the CH SEL button on the remote controller in the listening
position to select the channel (speaker) for adjustment.
2. Press the LEVEL π(up) /†(down) buttons to adjust the
volume level.
Adjusting the tone
Treble and Bass are effective only for the Front left and right speak-
ers or headphones.
The best results are obtained from DOLBY PRO LOGIC Surround
when the center and left and right front speakers contain the same
amounts of mid and high frequencies. As the Treble and Bass con-
trol do not affect the Center speaker, adjust the tone controls for the
left and right front speakers to match the sound produced from the
center speaker. Because of this, we recommend you use a good qual-
ity center speaker.
Adjusting the volume level of the subwoofer
You can adjust the volume level of the connected subwoofer. Press
the CH SEL button on the remote controller to display the SUB-
WOOFER indicator, and press the LEVEL π or † button to adjust
the level. (between – dB, –30 dB and +12 dB)