Table of Contents
Advertisement
Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2. Slide the solid-state drive into the solid-state drive slot.
3. Using the alignment post, place the solid-state drive thermal shield over the solid-state drive.
4. Align the screw hole on the solid-state drive thermal shield with the screw hole on the system board.
5. Replace the single screw (M2x4) that secures the solid-state drive thermal shield and the solid-state drive to the system
board.
NOTE:
Repeat step 1 to step 5 to install any additional solid-state drive in your computer.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Fan
Removing the right fan
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following image indicates the location of the right fan and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
21
Advertisement
Table of Contents
