Mounting On A Tripod; Floor Mount - DeWalt DW073 Instruction Manual

DW073/611118-01 5/13/02 4:37 PM
B
Pivoting Head is designed to lock the laser level into two
predetermined positions (level & plumb) through the use of a spring-
loaded detent pin. To make adjustments to the position of the laser
head follow these instructions.
1. Locate the Two-Position Pivoting Head Adjustment Lever (A) on the
side of the laser level, next to the "DANGER" warning label.
2. To pivot the laser head lift the Adjustment Lever approximately one
quarter of the way open, enough to disengage the spring-loaded
detent pin holding the laser head in position. DO NOT ATTEMPT
to fully open the Adjustment Lever, you may damage the spring-
loaded detent mechanism. The Adjustment Lever has been
designed to release the Pivoting Head when opened only one
quarter of the way.
3. While lifting the Adjustment Lever approximately one quarter of the
way open with one hand, pivot the laser head with your other hand
until it travels 90º to a stop.
4. Release the Adjustment Lever and make sure that the spring-
loaded detent pin locks into place. The laser head should now be
locked into position and ready for use.
Page 8
A
D
5. Follow the instructions for leveling or plumbing the laser. For posi-
tioning the tool for use on a wall see the Wall Mount section.
A
6. To return the laser head to its original position repeat steps 2-4.
Wall, Floor & Tripod Mounts
The DW073 Cordless Rotary Laser has been designed with the most
common accessories built directly into the base of the tool. These
C
accessories allow the laser to be mounted onto tripods, positioned
directly on the floor, and attached to walls for drop ceiling installation
or other leveling jobs.

Mounting On a Tripod

1. Position the tripod on a smooth and level surface. Set tripod to
desired height.
2. Secure the laser to the tripod base by screwing the threaded knob
(A) on the tripod into the 5/8" x 11 threaded insert on the bottom of
the laser level. NOTE: Be sure the tripod you are working with has
a 5/8" x 11 threaded screw.
3. Use the Two-Position Pivoting Head Adjustment Lever to pivot the
laser head for a level or plumb setting.
4. Follow the instructions for leveling or plumbing the laser.
5. Turn the laser on; adjust rotation speed and controls as needed.

Floor Mount

The laser level can be positioned directly on the floor for leveling and
plumbing applications. Follow the instructions below for using the floor
mount.
1. Place the laser on a relatively smooth and level surface
2. Use the Two-Position Pivoting Head Adjustment Lever (A) to pivot
the laser head for a level or plumb setting.
3. Use the Base Leveling Knob (B) located under the battery pack to
stabilize the tool and aid in rough leveling.
4. In a plumb orientation the laser can be positioned over a mark and
fine adjustments of the laser position can be made using the Base
Rack 'N Pinion Knobs. TIP: It may be helpful to turn the power ON
10