DeWalt DW073 Instruction Manual page 11

DW073/611118-01 5/13/02 4:37 PM
same level/plumb position that you initially set the laser to. The Bump
Sensor IS NOT AN OUT OF LEVEL SENSOR. It can not and will not
warn you if the laser has gone out of level without being bumped.
Check your level/plumb position often to ensure the accuracy of your
work.
BUMP SENSOR CONTROLS
The Bump Sensor is activated as soon as
you turn the laser power ON and will
remain active until you turn the laser
power OFF. Through the use of the Bump
Sensor Controls, you can choose how the
laser warns you in the event it has been
bumped. There are two settings to choose
from.
SETTING 1
FLASHING LED WARNING LIGHT ONLY
With a fully charged battery properly inserted, turn the laser power ON.
The Bump Sensor is automatically activated.
• Level the laser to establish a benchmark.
• Choose your rotation speed.
• If the laser level is bumped, the Bump Sensor WARNING LED (E)
will flash to warn you.
• To continue working, recheck the laser to your benchmark and re-
level if necessary.
• Press the Bump Sensor RESET Button (F) to clear the flashing LED
light and reset the Bump Sensor circuit.
SETTING 2
FLASHING LED WARNING LIGHT, FLASHING LASER DIODES,
AND ROTATION STOP
With a fully charged battery properly inserted, turn the laser power ON.
Page 7
A
9
The Bump Sensor is automatically activated.
• Level the laser and establish a benchmark.
• Choose your rotation speed.
• Press the Bump Sensor SET Button (C) to activate the second
operating mode. The Bump Sensor
ON LED Light (D) will illuminate.
• If the laser level is bumped, the Bump
Sensor WARNING LED (E) will flash,
the dual laser diodes will flash and
rotation of the laser head will stop, if
the rotary head was spinning.
• To continue working, recheck the
laser to your benchmark and re-level
if necessary.
• Press the Bump Sensor RESET Button (F) to clear the flashing LED
light and reset the Bump Sensor circuit. The laser diodes will stop
flashing and the rotary head will begin spinning again. The Bump
Sensor ON LED Light will remain lit and the tool will remain in this
operating mode.
To return the circuit to setting 1, press the Bump Sensor SET Button
(C) once again. The ON LED Light (D) will shut off indicating that the
laser is in operating mode 1.
Two-Position Pivoting
Head
This tool has been designed with a Two-
Position Pivoting Head for quick and
easy adjustments on the job. The Two-
Position Pivoting Head can be used to
position the laser for both horizontal
(level) and vertical (plumb) applications
and to adjust the laser for use with the
built in Wall Mount. The Two-Position
A
B A
C