Table of Contents
Advertisement
Removable Vehicle Components
Note: Four door storage in the cargo area
will prevent the soft tops from fully
retracting. Limit to the partially open
position.
Note: Make sure the rear seat headrests are
upright.
2. See Securing the Door Retention
Harness earlier in this chapter and
complete Steps 1-7.
3. Open the driver-side rear door and
install the bag. See Removing and
Installing the Doors (page 339).
E338915
4. Zip the bag fully closed and gently
place the door in the cargo area. Avoid
contacting the rear pillars, speakers,
striker, and trim. For soft tops, take care
to avoid contacting the prop rod.
5. Slide the door into position with the
bag label facing rearward.
2021 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202101, First-Printing
6. Align the door peak with the highest
point in the upper trim.
E339016
7.
Secure the door bag to the retention
harness with the clip.
8. Repeat Steps 3-5 for the remaining
doors. Secure the bags with the
harness clips.
Note: In order to store all four doors
onboard, you must store the doors in the
following sequence: driver-side rear,
driver-side front, passenger-side front,
passenger-side rear.
9. Lift the retention harness over the
doors. Make sure the straps are
straight.
10.
Secure the upper straps 5 and 6 to
the eyelet bolts and lower straps 7
and 8 to the rear cargo rings.
11.
Tighten all adjustable straps to
secure the doors.
Note: The doors should not move when
pressure is applied.
Note: When closing the tailgate, make sure
the tailgate and glass do not strike the
stowed doors.
358
Advertisement
Table of Contents
Troubleshooting
