Table of Contents
Advertisement
WARNING: Do not use the system
in poor visibility, for example fog, heavy
rain, spray or snow.
WARNING: You may need to
override the system when approaching
other road users.
WARNING: You may need to
override the system during inclement
weather.
AUTOMATIC HIGH BEAM
CONTROL REQUIREMENTS
The system turns the high beams on if all
of the following occur:
•
You switch the system on.
•
You set the lighting control to the
autolamps position.
•
The ambient light level is low enough
that you require high beams.
•
There is no traffic in front of your
vehicle.
•
The vehicle speed is greater than
approximately 32 mph (52 km/h).
AUTOMATIC HIGH BEAM
CONTROL LIMITATIONS
The system turns the high beams off if any
of the following occur:
•
You switch the system off.
•
You set the lighting control to any
position except autolamps.
•
The ambient light level is high enough
that you do not require high beams.
•
The system detects an approaching
vehicle's headlamps or rear lamps.
•
The system detects severe rain, snow
or fog.
2021 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202101, First-Printing
Exterior Lighting
•
•
•
SWITCHING AUTOMATIC HIGH
BEAM CONTROL ON AND OFF
1.
2. Press Vehicle Settings.
3. Press Lighting.
4. Switch Auto Highbeam on or off.
AUTOMATIC HIGH BEAM
CONTROL INDICATORS
OVERRIDING AUTOMATIC HIGH
BEAM CONTROL
E308790
Push the lever away from you to switch
the high beams on.
Push the lever away from you again to
switch the high beams off.
Push the lever away from you for a third
time to switch automatic high beam
control back on.
99
The system detects street lighting.
The camera has reduced visibility.
The vehicle speed falls below
approximately 27 mph (44 km/h).
Press Settings on the touchscreen.
Illuminates to confirm when the
system is ready to assist.
Advertisement
Table of Contents
Troubleshooting
