Setting Up the Filter Pump
WARNING:
Climbing hazard! Please prevent children from climbing on the filter
canister to gain access to the pool.
STEP 1: Install the Skimmer
1. Set up your pool following the instructions in
the Pool User Guide. DO NOT fill with water until
the Filter Pump is properly installed. Locate the
Skimmer Opening on the pool wall.
Pool Inlet
3. Insert the threaded part of the Skimmer Canister
secure with the Skimmer Seal Ring
Skimmer Opening
d
Pool Interior
Pool Exterior
2. Turn counterclockwise to remove the
Skimmer Seal Ring
Skimmer Gasket Rubber Seal
correct position.
d
through the Skimmer Opening, and then
9
.
Make sure that the pool liner is
placed tight on the Gasket
and is NOT trapped in the threads;
otherwise leaks may occur.
Thread slots
12
. Make sure the
d
h
No gap here
h
is in the
h