Use Of Pump; Pump Motor Care; Pump Maintenance; Filter Cartridge Use And Care - Polygroup SUMMER WAVES RX330 Owner's Manual

1. Plug the GFCI Power Cord Set
j
2. To turn on the Pump, press the RESET button of the GFCI Plug.
3. From inside the pool, check if the water flow from the RF Diverter
returning to the pool. If not, or if you feel a reduction in flow, clean or replace the Filter Cartridge
FILTER CARTRIDGE USE & CARE below as well as Symptom 2 of TROUBLESHOOTING GUIDE (p. 17).
4. To turn the Pump off, press the TEST button of the GFCI Plug, and unplug it from the power outlet.
5. VERY IMPORTANT: Check and adjust the pH and chlorine levels daily.
FILTER PUMP ALONE WILL NOT PREVENT ALGAE FROM GROWING IN POOL WATER;
THIS CAN ONLY BE DONE BY MAINTAINING PROPER CHLORINE AND pH LEVELS AT
ALL TIMES. For details, see POOL WATER CARE (p. 13).
IMPORTANT!
This Cartridge Filter Pump is protected by a thermal switch, a safety device that stops the pump from running when it's overheated, to prevent
pump damage and prolong service life. If your pump turns off automatically, it's likely the pool water temperature is too high or the water flow through the pump is
insufficient for cooling the pump down. Check and correct the water flow, make sure motor rest 15 minutes at least and then restart the pump by pressing the RESET
button of the GFCI Plug, or run the pump at night when the temperature is lower. If pump turns off automatically again, insepct your pump rotor block by dirt.
1. Check the pump output daily. If water flow reduces, see Symptom 2 of TROUBLESHOOTING GUIDE (p. 17).
2. Check the Pump, Hoses and Fittings for leaks. If a leak is found, see Symptom 4 of TROUBLESHOOTING GUIDE.
3. It's essential to replace any damaged parts as soon as possible. Use only spare parts from approved, reliable dealers, or from polygroupstore.com
4. Inspect the filter and all filter media regularly to ensure that there's no build-up of detritus that prevents good filtration. See FILTER CARTRIDGE USE & CARE below.
5. Run the Pump for the recommended number of hours daily. If you are unsure of the time frame, please see Pump Operation Hours at support.polygroupstore.com.
1. To clean the Filter Cartridge
a
a. Unplug the Pump from the power outlet.
For the Suction Fitting : seal it with the SF Cap
2
For the Return Fitting : remove the RF Diverter
6
the Service Plug .
8
8
2
5
12

USE OF PUMP

to a properly grounded receptacle at least 15 feet (4.5m) away from the pool.
7

PUMP MOTOR CARE

PUMP MAINTENANCE

FILTER CARTRIDGE USE & CARE
:
.
5
, and seal it with
7
6
7
Inside Pool Wall
is correct. It should feel like a solid stream of water
. For details, see
a
IMPORTANT: Do NOT connect to a timer device!
b. Vent the Pump by slowly loosening the Vent Screw
See SETUP INSTRUCTIONS (9), p.11.
14
How to use the GFCI plug
Press
"RESET"
Button
To Start
Pump
Operation
26
*Do not connect
to a timer device
counterclockwise.
e
12