ABB PDCOM Installation Manual page 17

DISTRIBUTION SOLUTIONS
If the device is installed inside an enclosed cabinet,
please check that there is enough space all round so
that the connectors and cables can be fitted.
PDCOM installation procedure in the LV cabinet
(closest to PDCOM interface):
Figure 20: PDCOM connections
Then remove the switchgear ground connection
Figure 21: PDCOM installation completed
Step 1: Install the Power Supply (24Vdc) (5.1)
Step 2: Connect the cable coming from PDCOM
interface (5.2)
Step 3: Connect the RJ45 form the SWICOM (to the
P3 port of SWICOM)
Step 4: Connect the PDCOM to SWG ground
The connect should as short as possible and done
by a grounding braid
17