Pioneer MAC-V700 Service Manual page 97

(2) Operations in Service Mode
To enter Service mode, press the [0] and [ENT] buttons simultaneously and hold for about 4 seconds until the mode indicator lights.
Each service mode is expressed by two-digit number, the mode type by the left-hand digit (0 to 8). The meaning of the right-hand digit
(submode) differs according to the mode.
The initial mode is Mode #0, version indication mode. To enter a desired mode, enter the mode number by pressing a numeric button, then
press the [ENT] button. You can omit pressing 0 for the right-hand digit.
[ 1 ]
In Modes 1, 2, 5 and 6, the ENT button can be used to increment the number of the submode.
[ ENT ]
Changer Error
History Reference mode
In the modes other than above, the [ENT] button cannot be used to increment the submode number. Press the [ESC] button to return to Mode
0, then directly input the desired mode number.
To quit Service mode to return to Normal mode, press the ESC button while in Initial mode (Mode 0).
(3) Indication of Version and Serial Number (Mode 0)
This is the initial status displayed immediately after entering Service mode. The firmware version is displayed. The version of the changer is
displayed on the mode indicator and on the screen of a monitor connected via the monitor output port. The firmware version of the decoder and
players #1 and 2 are displayed on the screen of a connected monitor. The serial number is also displayed on the monitor.
Representing the type of service mode
Representing version "0101" of the changer
In this system, the firmware version is expressed in four numerics. The fourth and third digits represent the version of the distributed
application.
[ ENT ]
[ ENT ]
Player #1 Error
History Reference mode
SERVICE MODE 0
MODEL NAME MAC-V700
SERIAL NO. SETT000001JP
VERSION
MAIN 0101
CHANGER 0101
PL1 0101
PL2 0101
Type of Service mode
[ ENT ]
Player #2 Error
History Reference mode
APPLI
01
01
MAC-V700
Decoder Error
History Reference mode
97