Installation And Operation; Unpacking; Installation And Connection - Ilmvac MPC 104 Tp Operation Manual

Installation and Operation

5 Installation and Operation
5.1

Unpacking

Carefully unpack the diaphragm pump.
Check the pump for:
• Transport damage,
• Conformity with the specifications of the supply contract (type, electrical supply data),
• Completeness of the delivery.
Please inform Ilmvac GmbH without delay if there are discrepancies between the delivery
and the contractually agreed scope of delivery, or if damage is detected.
Please take note of the general terms of business of ILMVAC GmbH.
In case of a claim under warranty, the device must be returned in packaging that is
suitable for protecting it during transport.
5.2

Installation and Connection

1. Set the diaphragm pump on a flat and
horizontal surface.
2. Remove the protective caps on the
suction (2) and pressure ports (1).
3. Connect the NW 8 vacuum
connector to the suction port (2).
4. Voltage selector 115/230 V (3)
Label on pump:
5. Connect the diaphragm pump to the
electrical supply (earthing plug).
6. Power switch (4)
12
Fig. 4 Diaphragm pump MPC 104 Tp
rear side
400082
( 1 )
( 2 )
( 3 )
( 4 )