Installation And Operation; Unpacking; Installation And Connection; Operation - Ilmvac MPC 301 E Operation Manual

Installation and Operation

5 Installation and Operation
5.1

Unpacking

Carefully unpack the diaphragm pump.
Check the pump for:
• Transport damage,
• Conformity with the specifications of the supply contract (type, electrical supply data),
• Completeness of the delivery.
Please inform Ilmvac GmbH without delay if there are discrepancies between the delivery
and the contractually agreed scope of delivery, or if damage is detected.
Please take note of the general terms of business of ILMVAC GmbH.
In case of a claim under warranty, the device must be returned in packaging that is
suitable for protecting it during transport.
5.2

Installation and Connection

1. Set the diaphragm pump on a flat and horizontal surface.
2. Remove the protective caps on the suction port.
3. Prepare the connections.
4. Connect the DN 8 vacuum line to the suction connection.
5. Connect the diaphragm pump to the electrical supply.
6. If the exhaust pipe is to be connected, fit the supplied hose nipple. The sound absorber is
to be mounted when the exhaust pipe is free.
The muffler used in the chemical area has only a limited chemical durability.
5.3

Operation

Observe the basic safety instructions when using the pump.
The diaphragm pump is switched on and off at the operating switch.
12 4000732
CAUTION !
CAUTION !