Topside Panel Display Messages; Variable Air Therapy System Control Functions - Hydropool 14IX Owner's Manual

Hr
- An internal hardware error has been detected
Prr
- The Prr error message indicates a problem with the regulation probe. The system is constantly verifying if the tem
perature probe reading is within its normal limits.
HL
- The water temperature at the heater has reached 119
FLO
- The system did not detect any water flow while the filtration pump was running.
UPL
- No low level configuration software has been downloaded into the system.
AOH
- The temperature inside the spa skirt is too high, causing the internal temperature in the spa pack to increase
above the normal limits.
OH
- The water temperature in the spa has reached 108
OPTIONAL VARIABLE AIR THERAPY
SYSTEM CONTROL FUNCTIONS:
Press: Blower button on main control to activate system.
1) ON/OFF :
Press 1: The Blower starts at maximum Speed. LED: ON
Press 2: The blower stops. LED: OFF
2) TO CONTROL SPEED:
Press 1 and hold: Speed goes up or down, LED: ON when pressing. Release
pressure at the desired speed.
3) TO CONTROL PULSATION:
Press 1: Slow Pulsation Cycle, LED: ON.
Press 2: Quick Pulsation Cycle, LED: Flashes.
Press 3: Pulsation Cycle OFF, LED: OFF.

TOPSIDE PANEL DISPLAY MESSAGES

o
F (48
o
F (42
27
o
C). Do not enter spa water.
o
C). Do not enter spa water.
2
1
3