PIONEER DJ serato DDJ-FLX10 Instruction Manual page 142

 Using an effect
1 Press the [BEAT ] button or [BEAT ] button while holding the
[SHIFT] button.
Select the BPM measurement mode.
– [AUTO]: Press the [BEAT ] button while holding the [SHIFT] button. The
BPM is automatically measured from the input audio signal.
– [TAP]: Press the [BEAT ] button while holding the [SHIFT] button. Enter
the BPM manually.
2 Turn the [BEAT FX] select knob.
Selects a type of effect in Serato DJ Pro.
3 Turn the BEAT FX CH select knob.
Selects a channel to apply the effect to.
– [SP]: Applies the effect to the sampler sound.
– [MIC]: Applies the effect to the microphone sound.
– [1] to [4]: Applies the effect to the sound of the respective channel.
– [MST]: Applies the effect to the sound of the master channel.
• Set [Sample Player Output Select] to [A] in Serato DJ Pro.
• For microphone sound and external input sound, the effect from the unit will
be applied.
 Read: Beat FX types on the unit (page 143)
4 Press the [BEAT ] button or [BEAT ] button.
Sets the number of beats synchronized to the effect sound.
The effect time corresponding to the number of beats is set automatically.
5 Press the [BEAT FX ON/OFF] button.
The effect is applied to the sound.
You can adjust the parameter of the effect by turning the [BEAT FX LEVEL/
DEPTH] knob.
The [BEAT FX ON/OFF] button flashes when the effect is on.
• Press the [BEAT FX ON/OFF] button again to turn the effect off.
142
En
Serato DJ Pro