Table of Contents
Advertisement
1
Checking the IRD
Select IRD_CHECK and press the Return key. The following screen is displayed.
A
B
From this screen the IRD can be controlled by two methods.
1. MAKE CHECK_STEP commands.
The selected command is displayed at the top of the screen (i.e. STEP:006 Tuner Check above).
C
Press the Return key to transmit the selected command to the IRD. If the IRD operates normally for the transmitted command, " OK "
will be displayed. If a problem exists, " NG " will be displayed.
It is possible to select which step will be transmitted using the up and down arrow keys.
2. Function Keys.
(f1~f4) Set Tuning Parameter 1~4: Used to set the parameters of the received signal.
After completion of settings, the data is transmitted to the IRD by pressing the " f9 " key.
D
E
(f5) Set the state of the IRD: This is used to set slow switch level, etc.
F
36
1
2
DBR-TF100
2
3
3
4
4
Advertisement
Table of Contents
