Hama A50 - Travelling Alarm Clock Instruction Manual

Table of Contents

Contents

1 Operating instruction
- 1.1 Safety Notes
- 1.2 Batteries
2 Getting Started
3 Operation
- 3.1 Setting the time
- 3.2 Alarm
4 Warranty Disclaimer
5 Service and Support
6 Technical Data
7 Documents / Resources
- 7.1 References
- 7.2 Download manual

Operating instruction

Safety Notes

The product is intended for private, non-commercial use only.
Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
Do not drop the product and do not expose it to any major shocks.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Do not modify the product in any way. Doing so voids the warranty.
Keep the packaging material out of the reach of children due to the risk of suffocation.
Dispose of packaging material immediately according tolocally applicable regulations.

Batteries

Immediately remove and dispose of dead batteries from the product.
Only use batteries (or rechargeable batteries) that match the specified type.
When inserting batteries, note the correct polarity (+ and - markings) and insert the batteries accordingly. Failure to do so could result in the batteries leaking or exploding.
Do not overcharge batteries.
Keep batteries out of the reach of children.
Do not short circuit the batteries/rechargeable batteries and keep them away from uncoated metal objects.

Getting Started

To open the battery compartment, press the edge of the battery compartment lid upwards gently by the groove on the underside of the alarm clock.
Remove the battery that was already inserted into the clock, remove the protective film if necessary as well as the contact interrupter and the re-insert the battery with the correct polarity.

Operation

Press the LIGHT/SNOOZE button to light up the display.

Setting the time

Turn the setting wheel on the back in the direction indicated by the arrow to set the current time (hours/minutes).
To set the seconds, remove the battery to stop the seconds. Put the battery back in to start the seconds hand again at the right second.

Alarm

Move the setting wheel on the back of the alarm clock in the direction of the arrow to set the appropriate alarm time. The hand for the alarm time moves in an anticlockwise direction.
Pull the sliding switch on the back outward or up () to enable the alarm. When the alarm is enabled, a coloured bar is visible from the front.
When the alarm time is reached, the alarm tone sounds, getting progressively louder.
Press the sliding switch down (), to shut off and disable the alarm.

warning
Note – Snooze function

While the alarm signal is sounding, press the LIGHT/SNOOZE button to activate the snooze function. The alarm signal will be stopped for 5 minutes, after which it will sound again.

Warranty Disclaimer

Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting from improper installation/ mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Service and Support

Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English) Further support information can be found here:
www.hama.com

Technical Data

Alarm Clock A50:
1,5 V
1 x AA battery

Hama GmbH & Co KG
86652 Monheim/Germany
www.hama.com

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.