Epson Equity 386/33 PLUS User Manual page 157

3. When the
Press <Del> to start
appears, press @@.
4. Highlight fun
SETUP menu.
Follow the instructions in Chapter 2 of the
set a new password or select Not Installed (if you do
not want to set a new password). Be sure to
SETUP information when you exit the program.
5. Turn off the computer and follow the instructions under
"Changing the Jumper Settings" in Chapter 4 to enable
the password function by setting jumper J3 to position B.
If you do not have a hard disk, insert the system diskette
6.
in drive A. Turn on the computer.
If you set a new password, you see the Enter
prompt. Enter the password to access your system. (See
"Using the Password" in Chapter 1.)
If you did not set a new password, you do not see the Enter
Password prompt and you can access your system
immediately.
Note
Be sure to remember your new password or write it down
and keep it in a safe place. If you forget the password you
enter now, you may have to repeat the above procedure the
next time you reboot your computer.
and press [En(wl. You see the
SETUP
SETUP prompt
to either
Setup Guide
save your
Password
Troubleshooting C-9