Epson Equity 386/33 PLUS User Manual page 131

You can stop testing at any time and return to the main menu
by holding down El
completes the current test before it stops.
You must enter certain parameters to run the hard disk and
diskette drive tests. If you use [F3) to select these tests, the
program prompts you for the parameters immediately. If you
use
the first pass of the test. If you perform the tests more than
once, the program uses the same parameters for each pass.
If you selected Passbound testing, the program displays the
pass number on the right side of the screen above the Run
time parameters window. For example:
Pass :
00001
If you entered
program pauses if an error occurs. When you press 0, the
program continues testing.
Note Note
Tests selected with (F31 and [FII remain selected until
Tests selected with (F31 and [FII remain selected until
you cancel them. Be sure to press m to cancel all you cancel them. Be sure to press m to cancel all
selections when you are finished running each set of tests.
the
wait on error prompt,
Performing System Diagnostics
the
B-9