If you selected Passbound testing, you see this prompt:
No. of passes : 00001
Specify the number of times (from 1 to 65535) you want to run
the test(s), or press [Enl#l without entering a number to select
the default of one pass. You can use the backspace key to make
corrections.
Note
In most cases, running a test once is sufficient. Multiple
passes test the reliability of essential functions only.
Error Logging
When you request error logging, you see this submenu:
Log errors on disk
Log errors to
Log errors to serial port
No error logging
Press [tl or [II to highlight the device on which you
want the program to log the error messages and press &@.
(Press c!3
prompt.)
If you select
error logging response
If you select the printer (LPT1), the program writes the error
messages to the device connected to the parallel port
LPT1. If you select the serial port, the program writes the error
messages to the device connected to the COM1 serial port.
B-6
Performing System Diagnostics
printer
error logging, the program changes the
No
from Y to
(LPT1)
N.
assigned