Table of Contents
Advertisement
3.
If you do not have a hard disk, insert a bootable diskette in
drive A. Turn on the computer and allow it to load the
operating system.
4.
Then turn off the computer, remove the cover, and enable
the password function by setting jumper J1 on the main
system board to position B. If necessary, follow the
instructions in Chapter 5 to replace any option cards you
removed.
5.
Replace the computer's cover.
If you do not want to set a new password, you do not need to
do anything else. (When you turn on your computer, you
will not see the Enter password prompt.)
If you want to set a new password, go to step 6.
6.
Insert the Reference 1 diskette in drive A and turn on the
computer. You do not see the Enter password prompt.
7.
Run the System Configuration program as described in
Chapter 2.
Select View or edit details for the system board. Then
highlight Power-on password and press [Enter.
8.
Type a new password at the next prompt and press [Enter]. If
you want to use network server mode, turn it on now.
9.
Save your configuration as you exit the System
Configuration program.
When the computer reboots, you see the Enter password
prompt. Enter the password to access your system.
Troubleshooting
C-10
Advertisement
Table of Contents
