Table of Contents
Advertisement
Starting the Program
Follow these steps to start the System diagnostics program:
1.
Insert the Reference 1 diskette in drive A and turn on or reset
the computer.
to start System diagnostics. This clears from memory
protected mode terminate-and-stay-resident (TSR)
After a moment, you see the title screen for the System
2.
Configuration program. Press any key to continue.
When you see the Welcome screen, press [Enter.
3.
From the Main Menu, select Access to other
4.
u t i l i t i e s . T h e n s e l e c t S y s t e m d i a g n o s t i c s .
When prompted, remove the Reference 1 diskette, insert the
5.
Reference 2 diskette, and then press IEnter
You see a menu bar at the top of the screen with Items
6.
Detected highlighted. Press m.
You see a list of all the testable devices the computer detects
7.
in your system. Check to be sure the list is correct.
8.
If the list is not correct, press I-] to select Quit and press
sure any missing devices are configured properly. Then run
System diagnostics again.
Running Systcrn Diagnostics
A-2
boot the computer from the Reference 1 diskette
or other utilities and frees it for use by the
Advertisement
Table of Contents
