Table of Contents
Advertisement
Reinstalling the lnternal Drive Housing
After you install or remove an internal drive, follow these steps
to reinstall the internal drive housing:
1.
Position the internal drive housing over the brackets inside
the computer and carefully lower it into place. Be sure to
keep one hand beneath the housing so it does not drop onto
the main system board or bump the processor board.
2.
Secure the housing to its brackets with the four retaining
screws.
3.
Locate one power supply cable for each drive installed in the
internal drive housing. You can use any of the cables
labelled P1 through P6.
Align the notched corners on the cable connector with the
notched corners of the drive socket, as shown below. Then
push in the connector.
6-18
Installing ~7uc1 Rer~mvirzg Disk Drives
Advertisement
Table of Contents
