Starting The Program - Epson Equity 4 User Manual

Starting the Program

Follow these steps to start the System diagnostics program:
1. Insert the Reference diskette in drive A and turn on or reset
the computer.
Note
Always boot the computer from the Reference diskette to
start System diagnostics. This clears any terminate-and-
stay-resident (TSR) programs or other utilities from
memory and frees it for use by the diagnostics program.
2. At the
3. You see a menu bar at the top of the screen with items
Detected highlighted. Press [burl.
4. You see a list of all the testable devices the computer detects
in your system. Check to be sure the list is correct.
5. If the list is not correct, press m to select mit and press
devices are configured properly. (See Chapter 2 of the
Setup Guide
again beginning at step 1.
When the list is correct, you can run diagnostic tests on each
device. If you do not want to test a device, you can remove
it from the list. You can also add a device to the list.
4-2 Running System Diagnostics
prompt, type
:
A
for instructions.) Then run System diagnostics
and press m.
DIAG