Epson CW3S16 Operation Manual page 180

Auto Interleave Routine
Warning!
The Auto Interleave Routine is a destructive operation.
Back up the hard disk(s) on which this routine will be
performed before actually performing the operation.
Run the Auto Interleave Routine to optimize hard disk
performance. This routine actually occurs in two separate steps.
First, the BIOS will calculate the optimum interleave value
through trial and error by measuring the transfer rate for four
different interleave values. During this process, a portion of the
hard disk is formatted to determine the best interleave value.
The BIOS will then format the hard disk using this interleave
factor. If a list of bad tracks is required before formatting the
hard disk, press <
Then, press
the Hard Disk Format Test. To perform the Auto Interleave
Routine:
At the Hard Disk menu, highlight "Auto Interleave" using
l
the bar cursor. Then, press
Auto Interleave Detection box to appear on the left side of
the screen. The box contains the following questions (fields)
that must be answered with appropriate responses. These
responses are addressed earlier in this tab under the heading
"Hard Disk Format Test."
Disk Drive C/D
Disk Drive Type
Proceed (Y/N)
to abort the second part of the test.
ESC >
<ENTER>
to return to the main menu. Perform
< ENTER
> . That causes the
Advanced ROM Diagnostics
?
?
?
E-17