Entering The Setup Program - Datatech Enterprises Apex 386/25 User Manual

Entering the Setup Program

There are two ways to enter the setup program: by pressing <F1> or
by pressing <ESC> .
1. Pressing <F1> to Enter the Setup Program
You will need to press <F1, to enter the setup program in the following
situations:
If the battery for CMOS chip is dead or the system configuration does
not match your actual hardware configuration, you will have to recon-
figure your system. The computer will give you this screen message:
Under the above three conditions, pressing <F1> will automatically
start the setup program.
Under any conditions within DOS, you can use the DOS DEBUG
command as follows:
This command will start the setup program.
12 Chapter 3: Operating Your System
• when your computer is turned on for the first time
• when the rechargeable battery is dead
• when the hardware configuration is changed
Press the F1 key to enter the setup program or
press any other key to continue
A>
DEBUG
-g=F000:FF60