Connecting Cables to Disk Drives
After you have screwed the disk drive securely in the disk drive bay,
you should connect the floppy/hard disk controller cables, the data
cable of the hard disk drive as well as one of the four cables from the
power supply. See the figures on the following pages.
The power cable is simple to connect: simply plug it to the correct
adapter. The shape of the plug ensures that no mistakes will be made.
3x the figures on the following pages.
One edge of the ribbon cable is marked with a color line. This specific
line side of the connector should be at pin 1 when attached to the
FDC/HDC card. Pin 1 is clearly marked on the card. See the figure
below for the color line of the cable:
To Pin 1 of HDC Connector
To Pin 1 of HDC Data Connector
Figure 6-5: Cables for Disk Drives
To Drive A
To Drive D
Chapter 6: Appendix
5