Locating The Printer - Epson Apex 110 User's Manual And Diagnostics

To connect your printer to a parallel interface:
1. Place the printer in a convenient location next to your system, as shown
in Figure 1-9 for example.
Before connecting any cables, make sure the power switches on both the
2.
main unit and the monitor are switched off, If you are not sure which
cable you need, consult your dealer.
One end of the printer cable has a 25-pin male D-connector. (Refer to
3.
your printer manual to determine which end this is.) Connect this end
to the socket marked
the plug has retaining screws, tighten them with a small screwdriver.
Connect the other end of the cable to the printer. To secure the cable,
4.
tighten the squeeze locks at each side of the printer port and into the
connectors on each side of the cable as shown in Figure 1-10.
Figure 1-9. Locating the printer
PARALLEL
on the back panel of the main unit. If
1-11