Inserting Option Card - Epson Apex 110 User's Manual And Diagnostics

Note: Pay specific attention to the warnings in your option card
instructions. Some devices have delicate CMOS chips you
should not touch.
When you handle the card, be careful not to touch any of the contacts
on the circuit board, especially along the gold edge connections. If you
need to put it down before installing it, place it with the component side
facing down on top of the original packing. Keep the card's original
packing materials in case you remove the card later.
3. Grip the card firmly by the top corners. The contact pins should be
pointing down and the components should face toward the inside of the
main unit.
4. Insert the card straight down into the slot as shown in Figure 3-4. Place
the tab at the bottom of the retaining bracket into the corresponding
notch at the back of the computer.
5. Once the connector pins are sitting in the connector slot, push down
firmly (but carefully) to fully insert the card. If the connector does not
seem to be going in smoothly, do not force it; pull it all the way out and
try again. Be sure to keep it straight.
3-4
Figure 3-4.
Inserting
option card