Configure a Beacon G6
Viewing device information and status
Viewing LAN status
4
Click LED Light to enable the LED light on the device.
5
Perform any of the following, as applicable:
• Reboot the device:
1. Click Reboot. A message displays asking if you want reboot the device.
2. Click OK to reboot the Beacon. The device reboots and displays the login page.
• Reset the device to factory default settings:
1. Click Factory default. A message displays asking if you want to reset the system
configuration to the factory default settings.
2. Click OK to reset the Beacon to the factory default settings.
E
ND OF STEPS
7.8 Viewing LAN status
1
Click Status→ LAN status in the left pane. The LAN status page displays the following
information.
Figure 7-4 LAN status page
70
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA
Beacon G6
June 2022
Issue 1