Configuring The Mac Filter; Table 7-30 Firewall Parameters - Nokia Beacon G6 Product Manual

Configure a Beacon G6
Security configuration

Configuring the MAC filter

2
Configure the following parameters.

Table 7-30 Firewall parameters

Field
Security level
Attack Protection
3
Click Save.
E
ND OF STEPS
7.45 Configuring the MAC filter
1
Click Security→ MAC filter in the left pane. The MAC filter page displays.
136
Description
Select the security level from the list:
• High: Pre-routing and application services are not supported. UDP Port 8000 can be used
to access the services. For example, FTP can use 8021 and Telnet can use 8023. Regular
UDP cannot be used. RG access is permitted via the LAN side but not via the WAN side.
• Low: All outbound traffic and pinhole-defined inbound traffic is allowed. Pre-routing is
supported: port forwarding, DMZ, host application, and host drop. Also supported are
application services: DDNS, DHCP, DNS, H248, IGMP, NTP client, SSH, Telnet, TFTP,
TR-069, and VoIP. The following types of ICMP messages are permitted: echo request and
reply, destination unreachable, and TTL exceeded. Other types of ICMP messages are
blocked. DNS proxy is supported from LAN to WAN but not from WAN to LAN.
• Off: All inbound and outbound traffic is allowed. No firewall security is in effect.
Select Enable or Disable from the list to enable or disable protection against DoS or DDoS
attacks.
Default value: Enable.
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA
Beacon G6
June 2022
Issue 1