Toro 78555 Operator's Manual page 14

Figure 18
60- and 72-inch mower deck shown
1. Blower assembly
2. Mower deck
3. Close the blower assembly to see if the latches
are adjusted correctly.
Note:
Loosen or tighten the bolt so the latches
firmly hold the blower assembly against the
mower deck, but can be released by hand
(Figure 19).
Figure 19
1. Latch
2. Bolt
4. Install the spring as shown in
Note:
Make sure that the hooks are in the
correct position.
g009220
3. Pivot hole
4. Blower-assembly peg
g003400
3. Blower assembly
Figure 20.
1. Spring-loaded idler pulley
2. Short-hook end
5. Pull the spring-loaded idler pulley back and
route the belt around the mower-deck pulley.
Note:
Ensure that the belt is routed around the
blower pulleys correctly
1. Mower-deck pulley
2. Spring-loaded idler pulley
14
Figure 20
3. Long-hook end
(Figure 21).
Figure 21
3. Blower
g003638
g003399