Figure 27
Twin bagger shown
1. Blower assembly
2. Lower tube
g003449
3. Latch (twin bagger shown)
Triple bagger shown
1. Blower assembly
2. Lower tube
10.
Make sure that the machine deck is in the lowest
height-of-cut position.
11.
Check to make sure that the mark from
25
is still in place.
12.
Using the 3 holes or indentations in the upper
tube as a template, drill 3 holes (7/32 inch
diameter) where the upper and lower tubes join
together
(Figure
17
Figure 28
3. Latch (triple bagger
shown)
29).
g003423
Figure