Epson BrightLink 455Wi User Manual page 153

If you're using AirPort, check the configuration of your network.
■
Start the AirPort Admin utility, select your base station, click
click
Configure and
tab. If you set up your projector to connect in DHCP mode, turn
on
Distribute IP Addresses
If you're using AirPort and DHCP is turned off on your
■
projector's Access Point mode advanced settings screen, make sure
Distribute IP Addresses
If you're using Access Point mode and you're connecting to the
■
wrong network, you may be experiencing signal interference from
another network. Try resetting your access point or base station,
then restart EasyMP Network Projection.
■ If you're using AirPort, the projector's SSID should match the
AirPort network name, not the name of the AirPort base station.
To check the network name, start the AirPort Admin utility,
select your base station, and click
. The network name appears on the AirPort tab.
All Settings
If you're prompted for a password when you connect, enter the
■
WEP encryption key (if you're using WEP encryption).
You are not receiving mail when a projector problem occurs.
■ Make sure the Mail settings are correct in the Network menu. For
details, see page 115.
■ To receive mail notification when the projector is in standby
mode, you need to set
in the Extended menu. See page 92.
. Click the
Show All Settings
and
Share a Single IP Address
is off.
Configure
to
Standby Mode Communication On
Network
.
. Then click
Show
Solving Problems
153