Table of Contents
Advertisement
Steps
1. Place the I/O daughter-board cable on the palm-rest and keyboard assembly.
NOTE:
For computers shipped with a plastic chassis, carefully slide the I/O daughter-board cable underneath the
wireless-antenna cables to place the I/O daughter-board cable on the palm-rest and keyboard assembly.
2. Connect the I/O daughter-board cable to the connector on the I/O daughter-board and close the latch.
3. Connect the I/O daughter-board cable to the connector on the system board and close the latch.
Next steps
1. Install the fan.
2. Install the
base
cover.
3. Follow the procedure in
I/O daughter-board
Removing the I/O daughter-board
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
M.2 2230 solid-state drive
4. Remove the fan.
About this task
The following images indicate the location of the I/O daughter-board and provide a visual representation of the removal
procedure.
74
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
or the
M.2 2280 solid-state
computer.
computer.
drive, whichever applicable.
Advertisement
Table of Contents
