Table of Contents
Advertisement
NOTE:
When replacing/reinstalling the system board, DO NOT install a screw to the screw hole at the top side the
system board.
5. Connect the following cables to the system board:
a. I/O daughter-board FFC
b. eDP cable
c. Power-adapter port cable
d. Keyboard FFC
e. Keyboard-backlight FPC
NOTE:
This step applies only to computers shipped with a keyboard backlight installed.
f. Touchpad FFC
g. Speaker cable
6. Close the right display hinge downwards to align the screw holes on the right display hinge to the screw holes on the system
board and the palm-rest and keyboard assembly.
7. Replace the two screws (M2.5x5) to secure the right display hinge to the system board and the palm-rest and keyboard
assembly.
Next steps
1. Install the
heat sink - integrated
2. Install the
3-cell battery
3. Install the fan.
4. Install the
wireless
card.
5. Install the
M.2 2230 solid-state drive
6. Install the
memory
module.
7. Install the
base
cover.
8. Follow the procedure in
or the
heat sink -
or the
4-cell
battery, whichever applicable.
or the
M.2 2280 solid-state
After working inside your
discrete, whichever applicable.
drive, whichever applicable.
computer.
Removing and installing Field Replaceable Units (FRUs)
123
Advertisement
Table of Contents
